IMPORTANT SAFETY INSTRUCTIONS
PROTECTION AGAINST TIPOVERS
(Continued)
8.DO NOT operate machine on slopes exceeding 10 degrees (18% grade) when towing. Cargo bed must be loaded when towing.
9.DO NOT put your foot on the ground to try and
stabilize the machine.
10.DO NOT operate machine under any condition where traction, steering or stability is doubtful.
11.DO NOT remove or modify the Operator Protective Structure. Operator and passenger must be properly seated and must wear seat belts, snuggly fastened, at all times.
12.DO NOT shift to neutral and allow machine to coast down slope. When descending a slope apply brake to maintain safe speed and drive straight. Avoid turning when descending a slope.
13.The use of a helmet, face shield or safety glasses and substantial clothing is recommended.
CARRYING LOADS
Carrying loads affects the handling, stability and braking of the machine. Improper loads, excessive speed, sharp turns, rough ground, loose or slippery surfaces and slopes can cause loss of control, sliding and/or
1.DO NOT exceed rated load capacity of the machine. Reduce load and speed when operating machine on slopes.
2.DO NOT carry
3.DO NOT stack loads higher than the sides of the cargo bed. Keep all loads as low as possible to minimize effect on stability.
4.Loads affect stability, handling and braking. Reduce speed, avoid sharp turns, and allow extra distance for braking.
5.DO NOT attempt to dump loads from cargo bed. Empty load before raising bed. Raising a loaded cargo bed can affect stability, resulting in
6.DO NOT drive machine with the cargo bed in a raised position.
7.DO NOT raise cargo bed when on a slope.
8.Tire pressure is extremely important to the handling, stability and braking of the machine. Tire inflation pressure must be maintained as specified on the machine and in this manual.
CARRYING LOADS (Continued)
9.Always release accelerator and apply brake when descending slopes to maintain safe speed.
10.DO NOT replace tires with different size or construction. Tire size and construction are critical to the proper handling and stability of the machine. Use only tires approved by manufacturer.
TOWING
Towing, as with carrying loads, affects the handling, stability and braking of the machine. Towing loads requires extra caution. Reduce speeds when towing and avoid slopes whenever possible. Allow extra distance for braking.
1.DO NOT exceed rated towing capacity of machine. Reduce load on slopes.
2.DO NOT exceed rated tongue capacity of hitch.
3.DO NOT modify hitch. Towed loads must only be attached to the hitch point provided on the machine.
4.DO NOT attempt to tow where steering, traction or stability is doubtful.
5.Tow loads at a speed slow enough to maintain control. DO NOT exceed 10 MPH while towing.
6.Cargo bed must be loaded when towing to provide adequate traction and braking.
7.DO NOT tow a load that you cannot safely control.
8.DO NOT tow loads on rough ground, or loose, slippery surfaces.
9.DO NOT allow children or others to ride on a trailer or towed attachment.
10.DO NOT tow the machine behind any other machine or vehicle.
PREPARATION
Read, understand and follow instructions and warnings in this manual and on the machine, engine and attachments. Know the controls and the proper use of the machine before starting.
1.Only mature, responsible persons shall operate the machine and only after proper instruction. The operator must possess a valid driver’s license.
2.Handle fuel with care. Fuels are flammable and vapors explosive. Use only approved fuel container. DO NOT remove fuel cap or add fuel with the engine running. Add fuel outdoors only with engine stopped and cool. Clean spilled fuel from machine. DO NOT smoke while refueling the machine.
3.Practice operation of machine in a flat open area free from obstacles and hazards. Operate at reduced speed until familiar with the handling of the machine and operation of all controls.
3
