SECTION 2 – OPERATING INSTRUCTIONS
2.1PRE-START CHECK LIST
Make the following checks and perform all service as required before starting and operating the machine.
2.1.1.Read Manuals. Read, understand, and follow instructions and warnings in this manual and all other supplied manuals, as well as instructions and warnings on the machine, engine and attachments. Know the controls and the proper use of the machine before starting.
2.1.2.Perform General Inspection. Thoroughly inspect the entire machine for damage, wear, and loose and missing hardware. Repair or replace damaged, worn, loose and missing components prior to starting and operating machine.
2.1.3.Check Tires. Check and adjust tire pressure to 15 psi. front and rear. Inspect condition of tires for wear, deterioration, cuts, and damage. Replace worn, damaged or deteriorated tires before operating machine, using only tires of original size, type and construction.
2.1.4.Check Accelerator Pedal. With engine off, depress pedal fully. The pedal must move freely, and immediately return to original position when released.
2.1.5.Check Engine oil and Transmission fluid. Raise empty cargo bed and carefully secure with prop rod. Add oil as needed to bring engine to FULL mark on dipstick. See Figure 2.1. Refer to Engine Owner’s manual for engine oil specifications. Add fluid as needed to bring transmission to FULL mark on dipstick. See Figure 2.1. Use MOBILFLUID 424 or equivalent.
IMPORTANT! Do Not overfill. Always fully thread dip stick when checking transmission fluid levels.
TRANSMISSION
FLUID
DIPSTICK/FILL
ENGINE
OIL FILL
ENGINE
OIL
DIPSTICK
FIGURE 2.1
2.1.6.Add Fuel to tank. (Refer to Engine Owner’s manual for fuel specifications.) Make sure fuel filler cap is tight after fueling. IMPORTANT NOTE: Always fuel machine out of doors, where fumes can safely dissipate. Do not smoke while fueling.
2.1.7.Check Steering for excessive play. Do not operate machine if steering is loose or sloppy.
2.1.8.Check Headlights. Both headlights should be functional before operating machine. Headlight lenses and rear reflectors must be clean. (NOTE: Ignition must be set to ‘Run’ position for headlights to function.)
2.1.9.Check Engine and surrounding areas for buildup of dirt, debris, oil, grease, etc.
IMPORTANT! ENGINE AND SURROUNDING AREAS MUST BE KEPT CLEAN. Debris buildup can cause engine overheating, severe damage, and fire.
2.1.10.Adjust Operator’s Seat. With engine stopped, and park brake set, loosen two seat adjusting knobs and move seat to desired position.
SEAT ADJUSTING
KNOBS
FIGURE 2.2
2.1.11.Check Seat Belts. Mounting hardware must be tight. Buckle must latch securely. Webbing must not display signs of deterioration, wear, or damage.
2.1.12.Check Operator Protective Structure (OPS). Check OPS for structural soundness (i.e. cracks, damage, etc.) All OPS mounting hardware must be tight. DO NOT operate a machine that has had the OPS removed, damaged, or modified in any way.
13
