![To Oil the Machine continued...](/images/new-backgrounds/52783/5278327x1.webp)
82387 No. 66
To Oil the Machine continued...
At the back of the machine is a round plate or cover, fastened by a thumb screw; loosen the screw, turn the plate upward and fasten by tightening the screw; turn the balance wheel slowly and oil the moving parts inside then turn the cover down and fasten it as before.
To reach the parts underneath the bed the
belt must be thrown off the band wheel on FIG. 18. OILING POINTS IN BASE OF MACHINE the machine stand. For this purpose the belt
shifter (F. Fig. 1, page 1) is placed at the front of the band wheel. By pressing the belt shifter lever to the left and working the treadle meanwhile, the belt is released and the machine can then be turned back on its hinges. The places to be oiled are indicated in Fig. 18, page 17, by arrows pointing to the oil holes and bearings.
To oil the stand, put a drop of oil on each of the places shown by arrows in the above illustration (Fig. 19).
FIG. 19. POINTS IN STAND
Table of Contents | Previous Page Next Page |
14