82387 No. 66
To Replace the Bobbin
Hold the bobbin between the thumb and fore- finger of the left hand, the thread leading on top from the right toward the left, as shown in Fig. 7.
Place the bobbin into the bobbin case and draw the thread into the slot (1, Fig. 8) in the bobbin case, as shown below.
Draw the thread backward between the bob- bin case and the tension spring until it reach- es the notch (2, Fig. 9) then pull the thread toward the right as shown in Fig. 9.
When closing the slide see that the thread is in the slot (3, Fig. 10) in the right edge of the slide, as shown below.
FIG. 7.REPLACING THE BOBBIN
FIG. 8. THREADING the BOBBIN CASE
FIG. 9. BOBBIN CASE THREADED
FIG. 10. UNDER THREADING COMPLETED
Table of Contents | Previous Page Next Page |
8
