82387 No. 66
To Wind the Bobbin
Release the balance wheel (E, Fig. 3, page
3)by turning the stop motion screw (D, Fig. 3, page 3) over toward you.
Place the bobbin on the bobbin winder spin- dle (E, Fig. 6, page 7) and push it up closely against the shoulder, having the small pin in the spindle enter the hole in the side of the bobbin. Put the spool of thread on the spool pin (1, Fig. 5). Pass the end of the thread into the thread guide (2, Fig. 5) then up into the lower eyelet (3, Fig. 6) of the bobbin winder thread guide, into the notch (4, Fig. 6) and pass the thread through the hole in the left side of the bobbin (5, Fig. 6) from the inside. Press the bobbin winder pulley (B, FIG. 6) down on the balance wheel hub and the latch (C, Fig. 6) will drop down and hold it. Then operate the treadle the same as for sewing.
Table of Contents
FIG. 5. MACHINE THREADED
FOR WINDING THE BOBBIN
Previous Page Next Page
6