Sirius Satellite Radio SR-101C manual Materials Required

The next diagram shows the same configuration as the previous illustration. You can see that one output of the multiswitch is connected to the input of the Combiner, and that there are no devices such a splitter or DishPro adapter in the common cable run between the Combiner and Splitter. If a DishPro adapter is needed, it must be installed after the Splitter as shown.

WITHOUT DISHPRO ADAPTER: WITH DISHPRO ADAPTER:

COMBINER

COMMON

CABLE RUN

MULTISWITCH

COMBINER

COMMON

CABLE RUN

MULTISWITCH

SPLITTER

SPLITTER

RECVR/TUNER

RECVR/TUNER

DISHPRO ADAPTER

SIRIUS RECEIVER

RECVR/TUNERs

SIRIUS RECEIVER

RECVR/TUNERs

Materials Required

In order to install the SIRIUS antenna and the Combiner and Splitter, you will need to purchase several lengths of RG-6 cables to complete your installation. The length of the cables needed is dependent upon your particular configuration. RG-6 cable is typically sold in lengths of 10, 25, or 50 ft., with “F” type connec- tors on each end. These cables may be purchased at your local hardware store, home center, or electronics retailer.

The cables which must be purchased are depicted in the following illustration as solid black and are numbered, while existing cables are shown as gray.

18 Home Signal Distribution Kit Installation Guide