After Multiswitch Configuration Installation Procedure (Multiswitch on Roof)
Once the antenna has been mounted according to the previous instructions, you can continue with the installation of the Combiner and Splitter:
1.Be sure that the satellite TV receiver/tuner is plugged into an AC outlet.
2.Take the RG-6 cable which you purchased to connect to the SIRIUS anten- na and thread one end of the cable through the opening in the end of the rubber boot. Then connect the cable to the antenna pod as shown in the illustration following. Slide the rubber boot over the cable connection to pro- vide a weather proof seal and install the cable tie around the cable directly below the rubber boot to prevent the rubber boot from slipping down. Trim off the excess cable tie. Route the remainder of the antenna cable to where you are locating the Combiner. When routing the antenna cable, be careful not to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture the external jacket of the antenna cable.
3.Connect one of the RG-6 cables you purchased from the SIRIUS antenna to the SIRIUS RADIO port on the Combiner (SR2261) as shown. (Refer to page 5 for the Combiner port identification.)
Step 2
EXISTING RG-6 CABLE
Step 3
(NOTE: Not present if multiswitch is integrated into the satellite dish)
M Multiswitch (NOTE: Multiswitch may be integrated into the satellite dish)
Step 5 | |
| Step 4 |
Combiner | EXISTING |
|
C | RG-6 CABLE |
|
32 | Home Signal Distribution Kit Installation Guide |
