SkyLink AD-433S manual Connect the DIAL-ALERT with Your Existing Alarm System

ADVANCED PROGRAMMING

CONNECT THE DIAL-ALERT WITH YOUR EXISTING ALARM SYSTEM

You may connect your existing alarm system with the Dial-Alertso that the dialer will be triggered by your alarm system when it is activated. There are 2 ways you can connect your dialer with your existing alarm system.

1.Connect the dialer with the alarm system using hard wire (normally closed).

2.Connect the dialer with the alarm system using the Alarm Sensor (SS-433).

Follow the diagram below for hardwiring the dialer with the existing alarm system. Every time the alarm system is activated, it will automatically trigger the dialer to dial out all the preset telephone numbers and play the pre-recorded message.

PANEL OR SENSOR N.C.. LATCHING DRY CONTACT* (NORMALLY CLOSED OPENS ALARM)

AD-433S

Remove the jumper first

Remove the jumper first

Place the Alarm Sensor beside the siren of your existing alarm system, once the alarm is activated, the siren will sound and the Alarm Sensor will be triggered and send a signal to the Dial-Alertto activated it. There is no wiring involved in this case.

The other way to trigger the dialer by the existing alarm system is to use the Alarm Sensor SS-433 in conjunction with the Dial-Alert, (see Additional Accessories page 25).

–21–