SkyLink am-100 manual Home Automation, Phone Number Programming

INSTALLATION

Phone Number Programming

You can program up to 5 Emergency Phone Num bers. When the system is in panic, the control panel will call these phone numbers and announce its status.

The following will need to be programmed:

-Phone memory (from 1 to 5), this is where the phone numbers will be stored

-Phone number, up to 29 digits.

-Redial count, this is how many times that phone number will be called, from 1 to 9 times.

-Repeat count, this is how many times the emergency message will be repeated, from 1 to 9 times.

Step	Keys	Function	Description	Note
1	[PROG]	Enter	Enter master password to	3 beeps for valid
			programming mode	password. 1 long beep
	[MPIN]	Programming
		mode		for invalid password.
2	[1]	Select phone		You will hear [Enter
		number		phone memory].
		programming
3	[1] to [5]	Enter phone	During emergency, phone
			memory 1 will be called first,
		memory
			then phone memory 2, 3, 4, and
			5. So phone memory 1 has
			higher priority.
4	[Phone	Enter phone	Phone number can be up to 29	You will hear [Enter
	number]	number	digits.**	Redial].
	+ [Arm]
5	[1] to [9]	Enter Redial	Redial is the number of times	You will hear [Enter
	+ [Arm]	count	that phone number will be	Repeat].
			called. Each phone number
			can have a different redial
			count, from 1 to 9 times.
6	[1] to [9]	Enter Repeat	Repeat is the number of times	You will hear [Phone
	+ [Arm]	count	that voice emergency message	Accepted] indicating the
			will be played, from 1 to 9 times.	phone number and its
			It is recommended to set up	settings have been
			the repeat time to 5 or more.	programmed successfully.

**Note:

You may enter a 3-second pause between digits by pressing [Mute] if needed. You may also enter consecutive multiple pause periods. For example, you may enter a phone number: (123)-456-7890 [Mute] 1234. After the phone number (123)-456-7890 is dialed, it will wait for 3 seconds, then dial 1234, which can be a password to a paging system, or an access code for a phone dialing system.

–10–

HOME AUTOMATION

	®
					This row	:
					Buttons to Disable Event Tigger
					Zone LED : Off
						Press once will enable “Event Trigger On”,
						press again will enable “Event Trigger Off”.
						This row of buttons operates in toggle manner,
						between event trigger on and event trigger off.
					This row	:
					Buttons to Enable Event Trigger
					Zone LED : 1) On (Event Trigger On)
						2) Flash (Event Trigger Off)
	DISABLE EVENT TRIGGER		ENABLE EVENT TRIGGER
Zone 1		Button [1]		Button [6]
Zone 2		Button [2]		Button [7]
Zone 3		Button [3]		Button [8]
Zone 4		Button [4]		Button [9]
Zone 5		Button [5]		Button [0]

–43–