SkyLink am-100 manual Control Panel, Programming Passwords, Changing Passwords, Trouble Shooting

TROUBLE SHOOTING

Control Panel

Questions	Solutions
Why I can’t arm my system?	Make sure none of the sensors are
	triggered. You can check this by the zone
	LEDs, none of them should blink.
I cannot arm the system even when no	You need to disarm the system again by
sensor is triggered, and the ARM LED	either entering the password or disarm by
is off.	keychain remote. Although the ARM LED
	is off, but the system is not completely
	disarmed after an alarm was triggered.
	Refer to page 19 on how to completely
	disarm a control panel after an alarm has
	been triggered.
Why the ARM LED keeps flashing?	That means you have not programmed any
	emergency phone numb ers. For instructions
	on how to program emergency phone
	numbers, please see page 10.
How do I exit programming mode	You can press the programming button on
when I’m in the middle of it?	the side of the unit to quit programming
	anytime.
When a sensor is triggered, the alarm	You have programmed that sensor in alarm
sounds instantly even it is not armed,	mode, instead of beep mode. Please refer
why is that?	to page 26 for instructions of how to program
	it back to beep mode.
When the alarm is triggered, why	The control panel will stop calling when it
the control panel won’t call all the	is disarmed by any one of the recipients.
programmed phone numbers? It	Disarm can also be done locally thru the
always stops before calling the	keypad on the control panel by entering a
last number.	valid password.
Why the control panel doesn’t beep	You have placed the buzzer mode selector
when a sensor is triggered, while	on the side of the control panel to “II”, this
only the zone LED flashes?	will disable the beeping. Placing it to “I” will
	enable the beeping.
The control panel is in armed mode,	If the triggered sensor is programmed in the
why activating a sensor will not cause	Alert Zone (Bypass Zone), alarm will not
an alarm, or call any emergency phone	sound, and emergency call will not be made
number?	if this sensor is triggered. The control panel
	will only respond when it is disarmed, in
	alert mode.

–44–

INSTALLATION

Programming Passwords

Master Password can be used for programming, arming, disarming the system, and telephone access. The default Master Password is [1234].

Secondary Password can be used for arming, disarming the system, and telephone access. Secondary Password cannot be used for programming. The default Secondary Password is [0000].

Duress Password is used when you are forcibly compelled to disarm the control panel. Entering the duress password will stop the siren from sounding but the control panel will silently call the emergency phone numbers for help. The default Duress Password is [3838]. You should definitely change this password and let all the users know this password.

Changing Passwords

It is strongly recommended to change all 3 passwords when you first set up the system.

In order to change the password, follow the procedures below.

Step	Keys	Function	Description	Note
1	[PROG]	Enter	Enter master	3 beeps for valid
	[MPIN]	Programming	password to	password. 1 long
		mode	programming mode	beep for invalid
				password.
2	[2]	Select
		password
		programming
3	[1] or	Select which	[1] - Master password
	[2] or	password to	[2] - Secondary password
	[3]	change	[3] - Duress password
4	[new	Enter new	Select any 4-digit pass-
	4-digit	password	word, each digit can be
	password]		from 0 to 9
5	[new	Enter new	Enter the new password	3 beeps if new pass-
	4-digit	password to	again for confirmation	word is accepted. You
	password]	confirm		will hear [Password
				Accepted]

–9–