ACCESSORIES
Additional sensors and transmitters as well as add on accessories are available to work with your system.
Door/Window Sensor (WD-101)
-Magnetic Contact Sensor
-For all doors or windows
- Batteries included
Repeater (RP-434)
- Extend the operation range between 2 wireless devices, such as any sensors and control panel
- Doubles the operation range automatically between sensors and control panel
INSTALLATION
Installing the Console
You must first determine where the control panel will be located. Please follow the criteria below to select the ideal location for the control panel.
-Place it within a few feet of an electrical outlet and phone jack
-Place it where it is easily accessible by you and other users
-Place it away from any doors or windows which could be accessed by non- intended users
-Place it away from extreme temperature sources such as oven, stove and away from large metal objects which could affect the wireless performance
After you have selected a location for the control panel, you are now ready to connect all the necessary wires and ready to power up the unit.
Water Sensor (FS-101)
- Alerts you when water is detected
- Ideal for water detection in basement, under the sink, even bathroom
Garage Door MonitorTM Sensor (GS-101)
(Available in US and Canada) - Monitors your garage door
- Alerts you when the garage door is left open
Garage Door MonitorTM Sensor (GS-102)
(Available outside US and Canada) - Monitors your garage door
- Alerts you when the garage door is left open
Indoor/Outdoor Motion Sensor (PS-101)
- Monitors area in a 110 degree ARC and up to 40 feet away from the sensor
1. Plug in the AC adapter to a nearbyelectrical outlet and plug the other end to the socket labeled “DC 12V” on the back of the control Panel. You should hear 3 beeps and “System Phone Failure” indicating the phone line is not connected. PWR, ARM and PROG LEDs should be flashing, LO BATT LED should be on.
2. Remove the battery cover on the bottom of the control panel with a Phillips screw driver, and insert 4 AAA alkaline batteries into the battery holder (note the polarity). After inserting the batteries, the LO BATT LED should be off.
3. Connect the phone line from the telephone jack to the back of the control panel where it marks “LINE”. PWR will stay on and PROG LED will stop flashing.
4.[OPTIONAL] If you have another telephone that will be using the same telephone jack, you may connect this telephone to "PHONE" outlet of the the control panel by a phone cord. (not provided).
5.Rotate the antenna to the upright position to ensure the best signal reception.
1
4
3
2
