INSTALLATION
6.For models with multiple languages, select the desired language based on the setting below.
[ 1 | ] - German |
| |
[ 2 | ] - Spanish | Language | |
[ 3 | ] - | French | selector |
| |||
[ 4 | ] - | English |
|
TROUBLE SHOOTING
Sensors
When a sensor is triggered, the | - Make sure the battery in the sensor is |
control panel doesn’t respond at all, | installed properly, pay attention to the |
what is the problem? | polarity. |
| - Make sure the sensor is learned to the |
| control panel. Follow instructions on |
| page 34 on how to learn a sensor. |
| - You may try to bring the sensor closer to |
| the control panel, ensure it is not out of |
| the operation range. |
|
|
My motion sensor sometimes gets | Ensure the motion sensor is not facing |
triggered by itself, how can I prevent | direct sunlight, nor any A/C or furnace |
that? | vents. You may also reduce the sensitivity |
| to low. If your motion sensor is located |
| outdoors, you may want to relocate it. |
|
|
After mounting the door sensor, it | - Please ensure the magnet is aligned with |
doesn’t work anymore. | the red marking on the transmitter. |
| - If you are mounting the sensor on to a |
| metal door or window, a spacer may be |
| required to avoid magnetic interference |
| caused by the metal door / window. |
| - Make sure the sensor is within the operation |
| range of the control panel by bringing it |
| closer to the control panel. |
|
|
My motion sensor is not very | The motion sensor is designed to detect the |
responsive, sometimes when I walk | “First Motion”. First Motion means no motion |
by it, the control panel doesn’t respond, | is detected within the past 20 seconds, |
but sometimes it does. | and if a motion is then detected, that is the |
| “First Motion”. So if you continue to walk |
| in front of the motion sensor, it will only |
| pick up the first motion. Unless you wait |
| for 20 seconds, then walk again, the control |
| panel will respond. Otherwise, the control |
| will only respond to the first motion. |
|
|