iv | IMPORTANT INFORMATION
• This projector detects its remaining lamp life. Replace the lamp when a lamp
life warning message appears. If you continue to use the projector after the
replacement message appears, the lamp can shatter or burst, scattering
glass throughout the projector.
• If the lamp has shattered or burst:
– Call your authorized SMART reseller for instructions. Do not attempt
to replace the lamp.
– Do not touch the glass fragments because they can cause injury.
– Leave and then ventilate the area where the lamp shattered or burst.
– Wash your hands thoroughly if you have come in contact with
lamp debris.
– Thoroughly clean the area around the projector, and then discard any
edible items placed in that area because they could be contaminated.
• You must remove the projector from its boom before servicing the lamp.
– Two people are required to remove and replace the projector.
– Replacing the lamp in a boom-mounted projector might result in a fall
or injury.
– Uncovering the lamp while the projector is mounted on the boom might
lead to product damage or personal injury from falling pieces of glass
if the lamp is broken.
• When replacing the projector lamp:
– Use only replacement lamps approved by SMART Technologies. Contact
your authorized SMART reseller for replacement parts.
– Never replace the lamp assembly with a previously-used lamp assembly.
– Turn the projector off and wait 30 minutes for the lamp to cool completely
before removing the projector from the boom.
– Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.
– To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.
– Do not remove any screws other than those specified in the lamp
replacement instructions.
– Recycle or dispose of the lamp module as hazardous waste,
in accordance with local regulations.