80 | CHAPTER 6 – MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM
WARNING
Cleaning a boom-mounted projector may result in a fall and injury. Use caution
when climbing a ladder.
CAUTION
• Before you clean the SMART UF65 or SMART UF65w projector, press the
Power button twice on the ECP or remote control to put the system into
Idle mode, and then allow the lamp to cool for 30 minutes.
• Do not spray cleaners, solvents or compressed air near any part of the
projector, since they can damage or stain the unit. Spraying the system could
spread a chemical mist on some of the projector’s components and lamp,
resulting in damage and poor image quality.
• Do not allow liquids or commercial solvents of any kind to flow into the
projector.
IMPORTANT
Follow these guidelines to clean the projector:
• Wipe the exterior of the projector using a lint-free cloth.
• If necessary, use a soft cloth moistened with a mild detergent to clean the
projector housing.
• Do not use abrasive cleaners, waxes or solvents.
• Avoid touching the lens. If it is necessary to clean the lens:
– Use liquids or commercial solvents (such as glass cleaners) to clean the
lens, but do not spray them directly on the system.
– Use protective gloves and dip a lint-free cloth (such as Purestat®
PW2004) in an anti-static solvent (such as Hyperclean® EE-6310).
– Gently wipe the lens from the center to the edge.