45 | CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
Source Selection Controls
These commands switch input sources. The source type determines which
commands can be accepted.
Source Selection Response Field Description
General Source Controls
The following source controls apply to all input sources. These controls are
unavailable when the projector is off. You can specify custom color values for all
inputs.
Source Information Commands
These commands inform you of the current source settings.
Command Response Available When
Powered Off
get input input=[field] yes
set input [field] input=[field] no
Field Description
VGA1 Switches source to the VGA 1 input connector.
VGA2 Switches source to the VGA 2 input connector.
Composite Switches source to the Composite video connector. If you
installed your interactive whiteboard system according to
the instructions, this is the relay from the ECP.
S-Video Switches source to the S-Video input connector.
None A non-selectable value that appears when you enter a “get
input” command while the projector is in Idle mode.
Command Response
get displaymode displaymode=[current display mode setting]
get brightness brightness=[current brightness setting]
get contrast contrast=[current contrast setting]
get whitepeaking whitepeaking=[current whitepeaking setting]
get degamma degamma=[current degamma setting]
get red red=[current red color setting]
get green green=[current green color setting]