ABOUT THE TIGERSWITCH 100
Status LEDs
The LEDs, which are located on the front panel for easy viewing, are shown below and described in the following table.
|
| Status |
|
|
| Activity |
|
|
| 1 | U |
Figure |
| ||
| Port and System Status LEDs |
| |
LED | Condition | Status |
|
Power | On | Switch is receiving power. |
|
RPU | On | Redundant power is on, and the RPU is in | |
|
| backup or active mode. |
|
| Off | Redundant power is off or has failed. |
|
Mgmt | On | Agent is operational. |
|
|
|
| |
Link | On | Port has established a valid network |
|
|
| connection. |
|
| Green | Valid 100 Mbps connection. |
|
| Flashing | Port has been partitioned due to an |
|
|
| abnormal network condition, or manually | |
|
| disabled. |
|
Act* | Flashing | Traffic is passing through the port. |
|
FDX* | On | Port is operating at full duplex. |
|
| Off | Port is operating at half duplex. |
|
FC* | On | Flow control enabled. |
|
* Use the Mode Select button to select the LED display mode.