INSTALLING THE SWITCH

100Base-FX -SC

SMC6900FSC

E

 

xtender

Module

 

Figure 3-4. Installing a Module

6.If you are sure the module is properly mated with the connector, tighten the retainer screws by hand to secure the module in the slot.

7.Connect power to the switch.

Stacking

A stack may have as many as four switches.

Note: A stacking cable is included with the Stack Module.

Caution: DO NOT stack TigerSwitch 100 units with other devices. Doing so may damage the switch.

To stack the devices:

1.Locate the stack connectors labeled “UP” and “DOWN” on the stack modules (see Figure 3-4).

2.Attach one end of the stacking cable to the stack connector labeled “DOWN” on the top device, and the other end to the connector labeled “UP” on the next lower device.

3-7

Page 45
Image 45
SMC Networks 100 manual Stacking, Installing a Module