![](/images/new-backgrounds/1146397/14639729x1.webp)
Specification ( continued )
Power Block
Power supply | ||
voltage range | ||
| ||
|
| |
Output method | PNP output | |
|
| |
| Max. 3.1A | |
Supply current | (When it is operated with the current between 3.0A and 3.1A, the ambient tem- | |
| perature should be 40 deg.C or lower and the cables should not be bundled.) | |
|
|
Wiring
Output wiring
Cable wiring
Aligning the key groove with the output connector (socket) of Output Block, plug in the cable with connector (plug).
Tighten the lock nut on cable side by turning it clockwise by hand.
Confirm that the connector does not move.
Output connector pin layout
(M12 connector, 5 pin, Socket)
Wiring ( continued )
Pin alignment and connection drawing of the Output Cable
| 52 | 6.4φ |
|
| M12 |
| |
|
|
| |
|
| 30 | 5 |
|
| 50 |
|
| Model No. : |
| |
Pin No | Cable color: Signal name | 1 | 2 |
|
| ||
1 | Brown : NC |
|
|
2 | White : Output No.1/NC |
| 5 |
|
| ||
3 | Blue : GND | 4 | 3 |
4 | Black : Output No.0/Output No.1 |
|
|
5 | Grey : NC | Plug connector pin layout | |
|
|
NOTE
Mount a Waterproof Cap on each unused connector of Output Block.The proper use of Waterproof Cap can achieve IP67 Enclosure. (Tightening torque : 0.1Nm for M12) For Waterproof Cap, refer to "Option" (page 32) in this manual.
Correlation between output number and Output Block
The total number of Input and Output Blocks can not exceed 10.
SI Unit | OET1 | Power Block | OEP1 |
13
1 | NC *2 |
|
3 | GND | 1 |
5 | NC *2 | 4 |
Output connector "0" | 1 | |
| ||
|
| 4 |
5
5
2
Output No.1 *1
3
Output No.0
2
NC *2
3
*1) Output No.1 is connected to the pin No.2 of the output connector "0", and 2 output signals can be directly output from the output connector "0".
*2) NC : Not connected
BUS
02
PWR
13
Output connector "1"
The output number is 1, 2 ... from the SI Unit side.
26 | 27 |