INSTALLATION
•Three RJ-45 ports for connection to a 10BASE-T/100BASE-TX Ethernet Local Area Network (LAN). These ports can auto- negotiate the operating speed to 10/100 Mbps, the mode to half/full duplex, and the pin signals to MDI/MDI-X (i.e., allowing these ports to be connected to any network device with straight-through cable). These ports can be connected directly to a PC or to a server equipped with an Ethernet network interface card, or to a networking device such as an Ethernet hub or switch.
•One RJ-45 port for connection to an xDSL or Cable modem. This port is fixed at 10 Mbps, full duplex. Use a Category 5 cable to connect this WAN port to a xDSL or Cable modem.
•One RS-232 serial port to connect to an ISDN Terminal Adapter (TA) or to a PSTN analog modem.
•One parallel printer port that can be connected to a printer. This printer can then be shared by any LAN/WLAN users.
•Two antennas (dipole, omni-directional).
