CONNECT THE SYSTEM

Connecting the Power Adapter

Plug the power adapter into the power socket on the rear of the Barricade, and the other end into a power outlet. Check the power indicator on the front panel is lit. If the power indicator is not lit, refer to “Troubleshooting” on page A-1.

In case of a power input failure, the Barricade will automatically restart and begin to operate once the input power is restored.

Wall Mounting

There are 2 slots on the underside of the Barricade that can be used for wall mounting. The distance between the 2 slots is 120 mm.

You will need 2 suitable screws, the diameter would be 4.4 mm, to wall mount the Barricade.

To wall mount the unit:

1.Determine where you want to mount the Barricade.

2.Drill two holes into the wall. Make sure the holes are 120 mm apart.

3.Insert a screw into each hole, and leave 5 mm of its head exposed.

4.Maneuver the Barricade so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the Barricade down until the screws fit snugly into the wall-mount slots.

Note: When wall mounting the unit, ensure that it is within reach of the power outlet.

2-7

Page 21
Image 21
SMC Networks SMC7904WBRA2 manual Connecting the Power Adapter, Wall Mounting