Instructions for the Installer
2.INSTALLING THE APPLIANCE
It is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AS5601.
2.1 Positioning and levelling the appliance
The appliance is equipped with wheels and adjustable feet to simplify the positioning procedure. To use the front wheels, screw in the foot as shown here, so that the appliance rests on the front wheels. However, to allow the appliance to be moved freely it must be lifted at the back. To do this, proceed as follows:
use a 10 socket wrench to screw in the 2 hex nuts underneath the oven compartment: this raises the
appliance either to level it or to allow it to be moved around.
Once all procedures are complete, retighten the front feet and the hex nuts to set the cooker stable and level.
2.2 Electrical connection
Check that the voltage and size of the power supply line are as specified on the nameplate inside the storage compartment.
This nameplate must never be removed.
The plug on the end of the power supply cable and the wall socket must be of the same type (in compliance with the relevant national standards). Check that the power supply line is properly earthed. The use of reductions, adapters or junctions is not recommended.
The appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.
6
