Instructions for the user
10.5 What to do if.
The oven display is full | • Check the mains power supply. |
|
| |||||
off | • Check | whether an omnipolar switch | ||||||
|
| upstream from the oven feed line is in the | ||||||
|
| “ON” position. |
|
|
|
| ||
The oven does not | • Check whether the “showroom” mode has | |||||||
heat up |
| been set, for further details see paragraph | ||||||
|
| “Secondary menu” at page 19. |
|
| ||||
The controls do not | • Check whether the “child | |||||||
respond. |
| mode has been set, for further details see | ||||||
|
| paragraph “Secondary menu” at page 19. | ||||||
The cooking times are | • Check whether the “2300 W” mode has been | |||||||
longer than those |
| set, for further details see paragraph | ||||||
indicated in the table. |
| “Secondary menu” at page 19. |
|
| ||||
After the automatic | • | Verify | whether the | interlock | device | has | ||
“pyrolysis” cleaning |
| switched off. If it has not, the oven has a | ||||||
cycle (only on some |
| protection | device | that | does | not | allow | |
models) it is not |
| functions to be selected while the interlock | ||||||
possible to select a |
| |||||||
| device | is | active. | This | is because | the | ||
function. |
| |||||||
| temperatures inside the oven are still too | |||||||
|
| |||||||
|
| high to permit any type of cooking. |
| |||||
The display shows | • The interlock device has not hooked up to | |||||||
ERR 4 |
| the door properly. These might be because | ||||||
(on pyrolytic models |
| the door was accidentally opened during its | ||||||
only) |
| activation. Switch off the oven and switch it | ||||||
|
| |||||||
|
| on again waiting a few minutes before | ||||||
|
| selecting a new cleaning cycle. |
|
| ||||
If the door is opened | • | This is not a fault. It is a normal operation of | ||||||
during a ventilated |
| the appliance, useful for when cooking foods | ||||||
function, the fans |
| to avoid excessive heat escaping. When the | ||||||
stops. |
| door is closed, the oven will return to normal | ||||||
|
|
operation.
If the problem has not been resolved or for other types of faults, contact your local technical assistance centre.
41