Smooth Fitness CE-3.0 user manual Troubleshooting, Breakdown, SMOOTH CE3.0 ELLIPTICAL TRAINER

32

SMOOTH CE3.0 ELLIPTICAL TRAINER

TROUBLESHOOTING

Item	Breakdown		Troubleshooting
1	Computer will not	1.	Plug the power adaptor in to the wall outlet
	power up	2.	Plug the power adaptor jack in to the unit.
		3.	Test the wall outlet for power.
		4.	Test the power adaptor for the correct voltage output.
		5.	Check the power adaptor and adaptor wire for damage.
		6.	Check for damaged computer cables then reconnect the lower, upper and console
			cables found on page 5 and 10 of the assembly section.
2	No resistance level	1.When the resistance level is changed does the motor run?
	change		Yes
		2.Check for damaged computer cables then reconnect the lower, upper and console cables
			found on page 5 and 10 of the assembly section.
		3.	Retest resistance
3	NO Hand pulse	1.	Reposition hands on the pulse grip Do not hold one pulse grip with 2 hands.
	figure display	2.	Reconnect the pulse grip wire inside the pulse grip handle
		3.	Reactivate the computer
4	E-1	1.	E-1 Indicates the computer was not able to calculate the body fat., Reposition hands on
			the pulse grip. Do not hold one pulse grip with 2 hands.
5	E-4	1.	E-4 indicates the user’s age, height, weight values have exceed of the maximum setting
		range when entering the user information. Reenter values that do not exceed the
		maximum values.
6	E-2	1.	Check for damaged computer cables then reconnect the lower, upper and console
			cables found on page 5 and 10 of the assembly section.
		2.	Check the Motor and resistance cable for proper positioning.
7	No speed reading	1.Check the console together with the stage’s 9or12PIN connect cable, to see if the
			console are bad contact or get loose with the stage’s 9or12PIN connect cable.
		2.	Check the Motor distance have exceed of the setting range or not.
8	No display of	1.	Check for damaged computer cables then reconnect the lower, upper and console
	SPEED figure		cables found on page 5 and 10 of the assembly section.
		2.	Check the Speed SENSOR cable for damage and reconnect to the lower board.
		Check the speed sensor and speed sensor magnet for proper positioning.
9	Recovery function	1 Verify the console is in the STOP mode and is not in a program.
	does not readout	2.	Verify the pulse readout is functioning.
10	Noisy during	1.Check slider tubes for damage
	Movement	2.Clean slider tubes with liquid silicone
		3.Check pedal arm wheels for damage.
		4.Clean pedal arm wheels with mild detergent and lubricate with liquid silicone
11	Noisy handlebars	1.Disassemble lower handle bars and check for damage.
		2.Lubricate with white lithium grease and reassemble.