3.The support rod and frame rod must be inserted into the cover (A, figure 21) as follows.
a. The frame rod (C, figure 21) must be inserted through the bottom sleeve of the cover so that the two bent endsextend out openings, which are next to the cord loops (D). The frame rod position is indicated by dotted line (B, figure 22).
4. Insert the elbow(E, figure21) into thecoveropening. | “. |
5.Pick up the cover and place down onto theframe(A, figure 20) inserting the elbow (A, figure 23) into the bracket (B) (shown without cover for clarity). Pull the rubber strap (C) over the elbow and hook into bracket as shown.
Figure 21 . |
| Figure 23. (Shown without ccwer for clariw.) | |
| A. Elbow | ||
A. Cover | D. Cord Loops | ||
B. Bracket | |||
6. Support Rod | E. Elbow | c. strap | |
C. Frame Rod |
|
|
A. SUPPOR Rod Location | E. Clip |
~6. Frame Rod Location | F. Decal. Warning |
C. Cord Loop | G. Tube |
D. strap | H. Elbow |
b. The support rod (B, figure 21), which has eyebolt ends, must be threaded through the sleeve inside the cover. The position is indicated by dotted line (A, figure 22).
N O T E
When you pick up cover to place over the frame, be sure support rod (B, figure 21) is inside frame rod w
6 . On each side, place the eyebolt end of the support rod (B, figure 21) onto the frame rod, then insert frame rod (A, figure 24) through the frame (B). Insert clip
(C)through frame rod to secure.
7.Insert an“S” hook toeachend ofthestrap(D,figure
22). Hook one end through washer (E, figure 22) and pinch closed with a pliers.
8.Pull the cover down so it appears as in figure 22. To secure the front, pull the cord loops (C) onto the spacers. To secure the rear, hook the strap(D) onto back of cart as shown.
9.Install warning decal (F, figure 22) so it is visible from
A WARNING
It is important for the operator’s safety, that the warning decal he installed.
