INSTALLATION AND OPERATION

-

CART COLLECTOR

ASSEMBLY
1.
Remove all parts from inside the cart’s box. Open the
bag of parts and sort the fasteners into groups for
easier assembly of the cart (figure 16).
2. Turn cart box’on one side.
a. Bolt U-bracket to bottom of box with two 5/ 16
x
3/4 long round head bolts. Secure with two 5/ 16
lockwashers and nuts.
b. Bolt latch handle to front side of box. Place one
5/16
x
I long hex bolt with 5/16 flat washer
through the inside of the box. Next place a 5/ 16
flat washer, latch handle, 5/ 16 flat washer, spring
washer (side with grooves on outside), and
locknut. Tighten the locknut until the latch handle
rnOWS
slowly.
3. Bolt swivel wheel to the H-frame.
a. Place the head of the swivel (end with four slotted
holes) inSide the H-frame (side with the ends bent
upward).
b. Align the holes and place four 3/8
x
1
long hex
bolts with 3/8 flat washers throughthe head ofthe
swivel and frame.
c.
Secure with four lockwashers and nuts.
4. Turn cart’s box upside down and install H-frame to
U-bracket.
a. Align the two ends of the H-frame (end with the
swivel wheel attached) to the U-bracket and
secure with two 1/2x
I-1/4longhex
boltsand
l/2
locknuts.
b. DO NOT over tighten the locknuts. The box
pivots at this point for dumping.
5. Turn latch handle to lock the H-frame to the cart’s
box and turn cart’upright.
LATCH HANDLE
; : 2::: ;,i;E:hHee:sBo’t
2
-
5116
Spring Washers .
2
5/16
Nuts
2 Each 5/16x
3/4
Round Head Bolt,
5,,6
Lockwasher,
5/16
Nut
\
H-FRAME
SWIVEL WHEEL
4 Each
-
3/B
x 1 Hex Bolt, 3/B Flat Washer,
3/B Lockwasher, 3/B Nut
2 Each
-
l/2
x
l-1
/4
Hex Bolt,
l/2
Locknul