Snapper 1691525 manual Belt Retainer Nut

6.Install wing nut (G, figure I) assembly as follows.

Insert 5/ 16-18 x2-1/2&p&w and 5/ i6flat washer from inside the deck. Place the cup (H) onto the capscrew and install S/ 16 lockwasher and 5/ 16 nut. (Figure 12 shows correct position ofcup.)Thread the wingnut (A, figure 6) onto capscrew and install the 5/ 16 locknut (D) flush with end of screen.

7.The belt retainer (A, figure 5) must be positioned correctly. Loosen the nut(B) and position the leg(C) so it is against the side of the idler arm (D). Then, tighten the nut (B).

Figure 6.

A. Wing Nut

E. Belt Retainer c. Pulley

D. Locknut, S/,6

Figure 5.

A. Belt Retainer

6. Nut

c . Leg

D. Idler Arm

E.Notch

F.Spacer

G.Small Spacer

H.Stral, Notch

8.Install the blower assembly (figure 5) onto mower deck as follows. Note that the notch(E) will be placed onto small spacer(G) on top of the strap. The blower assembly spacer(F) will tit into the strap notch(H).

a.Slide the blowerintopositionasshowninfigure6. and tighten the wing nut (A).

b.Push the belt retainer(B, figure 6) to provide slack and install belt onto lower groove in pulley (C). (Rotate pulley while placing belt on.)

9.Place the deck drive belt in the upper groove of the pulley (C, figure 6).

10.This completes installation of the blower assembly. Install the tube and collection system by following directions provided in this manual. To remove the blower assembly, see “Operating Without Collection System.”

4