Snapper 1691525 manual Installation Blower ASSEMBLY, 36 Mower

INSTALLATION - BLOWER ASSEMBLY, 36” MOWER

I. Remove the mower deflector by rerpoving two carriage bolts, lockwashers and nuts. Save this hardware for use when blower is removed for side discharge.

2.Install strap (A, figure I) as follows:

a.Drill a 9132” hole for large spacer (B). Use the supplied template on the last page. Align template with deflector mounting holes (C).

b.Install strap (A, figure 1) to deck with hardware shown in figure 2.

c. Check the installation. The strap should be secured to deck with locknut (D, figure 1). The small spacer (E) should be above the strap. The large spacer (B) should be between strap and mower deck.

3.The belt stop (A, figure 3) and hardware must be relocated to hole (C) shown. Install self-tapping screw (B). which was removed. in place of belt stop.

Figure 3.

A. Belt Stop

g. Self-Tapping Screw

C. New Belt Stop Location

N O T E

To ease installation, engage PTO lever, so that brake is away from pulley.

4.Remove the existing right-hand arbor pulley and install the new double-groove pulley (F, figure I) with existing capscrew, lockwasher and washer. Torque to 55 to 70 ft. Ibs. Do not reinstall deck-drive belt at this time.

5 . Install the baffle (B, figure 4) as shown. Installretainer nut (E) in baffle, then screw the I/4” whizlock screw

(A)into retainer nut. Insert 1/4”caniage bolt (C) from inside deck and install lockwasher and nut (D).

Figure 1.	E. Small Spacer
A. Strap	F. Pulley
6. Large spacer	G. Wing Nut
C. Holes, Deflector Mounting	H. Cup
D. Nut, Center Lock, 5,,S	I. Locknut, 5/16
	Center Lock

Mower Deck

Figure 2.

A. Screw. Whizlock. l/4-20 x l/2 6. Baffle.

C. Bolt, Carriage, l/4-20 x 5/S D. Lockwasher and Nut, l/4

E. Retainer Nut

3