12.Open the oven door and remove the 2 screws on each side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control console will not rest in the side brackets properly once it is detached.
13.Pull up on the control console and let it drop forward into the notched console brackets on each side.
A
A. Control console bracket
14.Remove the round gasket from the valve stem.
15.Use a ¹⁄₈" x 4¼"
AB
A. Single flame burner adjustment screw (on right side of valve) B. Dual flame burner adjustment screw (on left side of valve)
16.Replace the round gasket.
17.Lift up on the control console and set it back into place. For a proper fit, the flange of the control console must hook over the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
18.Check that the control console is flush with the top edge of the range.
A
A. Flush with range top
19.Replace the 2 screws on each side of the control console.
20.Replace the control knobs.
21.Replace burner grates.
Complete Installation
1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.
2.Refer to the “Electronic Ignition System” section for proper burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" (0.64 cm) to ½" (1.3 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.
3.Refer to “Complete Installation” in the “Installation Instructions” section of this manual to complete this procedure.
20
