Complete Connection
1.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
2.Test all connections by brushing on an approved noncorrosive
3.Remove cooktop burner caps, burner bases and grates from parts package. Place burner bases on cooktop, burner caps on burner bases and place grates over burners and caps.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
4.Plug into a grounded 3 prong outlet.
5.Turn on power supply. For further information, please refer to the user instructions located in the Use and Care Guide.
Verify Anti-Tip Bracket Location
1.Turn all 4 leveling rods 1 full turn to raise the range and provide enough clearance for the rear leveling leg to slide into the
2.Move range into its final location making sure rear leveling leg slides into
NOTE: If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the “Location Requirements” section.
Level Range
NOTE: Range must be level for satisfactory baking performance.
1.Place rack in oven.
2.Place level on rack and check levelness of the range, first side to side; then front to back.
3.If range is not level, adjust the leveling rods. Turn leveling rods located behind the kick plate to level range and to raise or lower range to the desired countertop height.
NOTE: All roller feet must be off the floor upon final installation.
A
B
A
B
A. Front leveling rod
B. Rear leveling rod
Install Griddle
(on griddle models)
The griddle is factory installed.
1.Place drip tray in the well at the front of the griddle. Slide tray toward the back until it stops.
A
B
A. Griddle drip tray
B.Griddle
2.Clean griddle before using. Refer to the Use and Care Guide.
10
