Snapper NZMX30614KH, NZMX32734BV Operaadjustmentsingin TRUCTIONS&REPAIR, Traction Belt Tension

Section35--OPERAADJUSTMENTSINGIN TRUCTIONS&REPAIR

! WARNING !

DO NOT attempt any maintenance, adjustments or service with engine running. STOP engine. STOP blades. Set brake. Remove key. Remove spark plug wires and secure away from spark plugs. Engine and components are HOT. Avoid serious burns, allow suf- ficient time for all parts to cool.

5.3 TRACTION BELT TENSION

The traction drive belt tension does not require adjustment. If the belts are slipping, they will have to be replaced.

DISCONNECT CLUTCH FROM

MAIN WIRING HARNESS

TRACTION

BELT

ROUTING

TENSIONING

IDLER

ENGINE PULLEY (ABOVE CLUTCH)

STATIONARY

IDLER

PUMP

PULLEYS

FIGURE 5.10

(View looking up)

HEX NUTS

	REMOVE ANTI-ROTATION
EYEBOLT	BRACKET FROM FRAME

FIGURE 5.9

5.4TRACTION BELT REPLACEMENT

1.Remove clutch to deck belt. Refer to Section “Mower Drive Belt Replacement”.

2.Turn hex nuts out to the end of eyebolt, reducing spring tension. See Figure 5.9.

3.Remove hardware securing anti-rotation bracket to frame. See Figure 5.9. NOTE: Do not remove anti- rotation bracket from clutch.

4.Disconnect the electric clutch from main wire har- ness. See Figure 5.9.

5.Remove traction belts from around engine pulley and hydro pumps.

6.Install new belts, routing around engine pulley and hydro pump pulleys. See Figure 5.10.

7.Reconnect electric clutch to main wire harness.

8.Reinstall anti-rotation bracket to frame and tighten hardware securely.

9.Run hex nuts all the way to the end of the threads on the eyebolt. See Figure 5.9.

10.Reinstall electric clutch to deck belt onto electric clutch.

5.5BLADE BRAKE/ELECTRIC CLUTCH ADJUSTMENT The blade switch engages the electric clutch when pulled out to the "ON" position. When the blade switch is in the "ON" position the cutting blade(s) are engaged. The blade switch disengages the electric clutch when the blade switch is pushed in to the "OFF" position. When the blade switch is in the "OFF" posi- tion the cutting blade(s) are disengaged. The electric clutch is adjustable. The blades should stop rotation in 7 seconds or less. If the electric clutch fails to stop the blades rotation in 7 seconds, adjustment is necessary.

1.Insert a feeler gauge into the three slots on the electric clutch.

2.Check gap through all three slots in the side of the clutch. The gap should be set at .015.

3.If gap is incorrect rotate nuts in or out to achieve the correct gap. See Figure 5.11.

NOTE: Electric Clutch is shown removed from the machine. Removal is not necessary for adjustment.

INSERT FEELER GAUGE.

GAP SHOULD BE .015

ROTATE NUTS IN OR

OUT TO ACHIEVE

CORRECT GAP

FIGURE 5.11

23