Section 43 - MAINTENANCEOPERATING INSTRUCTIONS
4.3.3.RIDING MOWER - LUBRICATION 1. Front Wheel Bearings
Lubricate with Kendall NLGI No. 2 lithium grease or equivalent, from a grease gun. See Figure 4.5.
FRONT
WHEEL
HYDRAULIC FLUID RESERVOIRS
FIGURE 4.6
LUBRICATE
BEARINGS
FIGURE 4.5
2. Hydro Pumps
Check the level of the fluid in both of the fluid reser- voirs. Wipe away all dirt and debris from around reser- voir cap before removing. Oil must remain absolutely clean! Check with machine on a level surface with engine "OFF". Fill reservoir as needed to bring level up. The reservoir is properly filled when the fluid level is 1½" below the top of the filler neck. DO NOT OVER FILL. Use clean, fresh premium automotive oil having a viscosity equivalent to SAE 20W50 API SL. The fluid should be chemically stable, incorporating rust and oxidation inhibitors. Make sure funnels, pouring spouts and oil can are completely clean. Reinstall reservoir cap. See Figure 4.6.
NOTE: In order to raise operator seat to access reservoirs, seat must be in rearmost position.
3. Mower Deck Idler Arms
Lubricate mower deck idler arms with Kendall NLGI No. 2 lithium grease or equivalent, from a grease gun. See Figure 4.7.
4.4BEFORE OPERATING MACHINE
1.Clean all dirt and debris from around the two hydraulic fluid reservoirs, especially around the top and cap area.
2.Clean all dirt and debris from the cooling fins on the engine and from both hydraulic pumps.
LUBRICATE MOWER
DECK IDLER ARMS
FIGURE 4.7
4.5 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in Section "AFTER EVERY 25 OPERATING HOURS". Refer to Section "Service Schedule".
4.5.1. ENGINE
Service engine according to engine owner's manual.
(Continued on next Page)
17
