About the EthernetBlaster Communications Cable

2.Click the Change Settings tab and select DHCP from the Connection Type menu. See Figure 1–8below.

Figure 1–9. EthernetBlaster Change Settings Page

1Contact your network administrator if you do not know the settings to complete the Change Settings page.

3.Click Apply. The EthernetBlaster communications cable automatically restarts. When the status LED returns to a steady green state, the EthernetBlaster communications cable has successfully restarted and can now be added to the Quartus II software. See “Setting Up the EthernetBlaster Hardware in the Quartus II Software” on page 1–13.

Setting Up the EthernetBlaster Hardware in the Quartus II Software

Use the following steps to set up the EthernetBlaster communications cable in the Quartus II software.

1.Start the Quartus II software.

Altera Corporation

1–13

December 2004

EthernetBlaster Communications Cable User Guide