Cable Setup

2.Choose Programmer (Tools menu).

3.Click Hardware Setup. The Hardware Settings tab of the Hardware Setup dialog box is displayed.

4.Click Add Hardware. The Add Hardware dialog box is displayed. Select EthernetBlaster and click Auto Detect.

1The server name list is automatically populated with the EthernetBlaster communications cable detected on your subnet if Auto Detect is selected. However, if the cable is not on your subnet, you must manually type the name or IP address of the EthernetBlaster cable in the Server Name field of the Add Hardware dialog box.

If you are using a direct connection to your computer, type 192.168.0.50 in the Server Name field.

5.Type the server password in the Server password field (“password” is the factory default), and click OK.

6.EthernetBlaster is now visible in the Available hardware items list of the Hardware Setup dialog box, as shown in Figure 1–10below.

Figure 1–10. Hardware Setup Dialog Box

7.Click Close to close the Hardware Setup dialog box.

1–14

Altera Corporation

EthernetBlaster Communications Cable User Guide

December 2004