SONAMP® 875D SE
Auto-On
You can set your 875D SE so that any zone will automatically turn ON when it receives an audio signal, or when it receives a control voltage from an external source (such as a Sonance Navigator Harbor
NOTE: Setting both switches ON puts that zone in the Serial control mode, disabling the Auto On feature . (See Serial Control, on page 14 . )
AUTO (Audio) Trigger Mode
TRIGGER MODE |
| |||
CH 1/2 |
|
| AUTO | |
|
| VOLT | ||
CH 3/4 |
|
| AUTO | |
|
| |||
|
| VOLT |
| |
CH 5/6 |
|
| AUTO |
|
|
|
| ||
|
| VOLT | ||
|
|
| ||
CH 7/8 |
|
| AUTO |
|
|
| VOLT | ||
|
|
|
|
|
OFF ON
Figure 14:
When a zone’s AUTO switch is set to the ON position, any audio signal arriving at the zone’s active input connectors (as determined by the INPUT ASSIGNMENT DIP SWITCHES, see page 8) will activate the zone for operation. The sensitivity of the zone’s
•Turning the control clockwise increases the sensitivity (less voltage is required to trigger the
•Turning the control
The
| 3 – 4 |
| 5 – 6 |
L | R | L | R |
| AUTO ON |
|
Figure 15:
Zone AUTO ON (Audio)
Trigger Sensitivity
Adjustments
In the
VOLTAGE Trigger Mode
When a zone’s VOLT switch is set to the ON position it can be automatically turned ON by an external trigger voltage that appears at the zone’s EXTERNAL TRIGGER INPUT connections (see Figure 16).
• The trigger voltage must be between 5V and 24V, either AC or DC.
The 875D SE has individual EXTERNAL TRIGGER INPUT connections for each zone, and an additional EXTERNAL TRIGGER INPUT connection (labeled ALL) that will turn all 4 zones ON from a single voltage trigger.
ALL 1/2 3/4 | 5/6 |
| 7/8 CH | CH | ||||||||||||||
+ – + – + – | + – | + – | CH | |||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
EXTERNAL TRIGGER INPUTS 5 – 24V
Figure 16:
External Trigger Input
Connections
The EXTERNAL TRIGGER connectors feature
1.Open the levers for the zone’s EXTERNAL TRIGGER inputs.
2.Insert the control wires into the appropriate openings in the connector.
3.Close the levers.
12