To bring the cursor to the value you want to change Rotate the MULTI CONTROL knob.

To change a value

Rotate the MULTI CONTROL knob while holding the HOME button down.

For automatic assignment of network settings (such as IP address)

Set the IP address to “000.000.000.000” or “255.255.255.255.”

When the e-VTR is turned on, the network settings are automatically assigned.

Notes

•If the IP address is set to “000.000.000.000” or “255. 255.255.255,” the IP address, subnet mask, and default gateway are automatically assigned. In this case, step 7 below is unnecessary.

•If automatic assingment is active, M51: SUBNET

MASK and M52: DEFAULT GATEWAY are not displayed.

•For automatic assignment of network settings, a DHCP server or a DHCP relay agent must be installed on the same network as the e-VTR.

•If network settings are automatically assigned, the IP address may change whenever the e-VTR is restarted. To prevent this, the IP address for the hardware address of the e-VTR should be defined in advance on the DHCP server. The hardware address can be confirmed on the Network Interface page (see page 45) of the Web application.

6 When you have set the value, press the F5 (SET) button.

The message “Save Complete” appears.

M5 : NETWORK

M50 : IP ADDRESS

192.168. 0. 123

Save Complete

To set the default gateway

Bring the cursor to M52: DEFAULT GATEWAY in step 4.

8 Restart the e-VTR, or operate M58: M50-M52 RENEW to apply the changes to the network settings.

Checking the state of the network

The network indicator lights or goes out as follows, according to the state of the network.

Not lit: No FTP connection

Lit: FTP control connection

Blink: FTP data connection

NETWORK button

Full access to the network is possible when the NETWORK button is lit. When the NETWORK button is not lit, limited network access is permitted for the functions indicated below.

•Access via link layer (ping response, etc.)

•Web browsing

7 Set the subnet mask and default gateway in the manner which is explained in steps 4 to 6.

To set the subnet mask

Bring the cursor to M51: SUBNET MASK in step 4.

10 Preparations