Enabling the REC Command via a Network for a Cassette with a Memory Label

Execution of the REC command via a network when using a cassette with a memory label attached is normally disabled to prevent overwriting of a file that has been already received.

However, you can execute the REC command via a network for a cassette wtih a memory label in a case in which no file has been created by any user.

1 Do steps 1 to 3 of “Basic Network Settings” (see page

9)to display the M5: NETWORK page of the maintenance menu.

2 Rotate the MULTI CONTROL knob to bring the cursor (*) to M57: OTHERS CONFIG, and then press the F5 (SET) button to display the sub-page.

3 Rotate the MULTI CONTROL knob to bring the cursor (*) to M571 REC WITH TELE-F, and then press the F5 (SET) button.

OTHERS CONFIG

M570: REC WITHOUT TELE-F

M571: REC WITH TELE-F

M572: TEMP FILE CREATE

The M571: REC WITH TELE-F setting page appears.

4 Rotate the MULTI CONTROL knob to change the setting.

OTHERS CONFIG

M571: REC WITH TELE-F

enable

Push SET button

enable: If no file has been created, execution of the REC command execution is enabled even if the cassette inserted in the e-VTR has a memory label.

disable (default setting): REC command execution is disabled for any cassette inserted in the e-VTR that has a memory label.

5 Press the F5 (SET) button.

The message “Save Complete” appears.

Enabling File Creation Exceeding the Capacity of a Memory Label

Creation of a file exceeding the capacity ot the memory label attached to the cassette is normally disabled. With the following menu operation, you can enable continuous file creation even after the capacity of the memory label is exceeded. Note that the files to be created after the capacity of the memory label is exceeded will be temporary files.

For the temporary files, see the description under “File list” on page 25

1 Do steps 1 to 3 of “Basic Network Settings” (see page

9)to display the M5: NETWORK page of the maintenance menu.

2 Rotate the MULTI CONTROL knob to bring the cursor (*) to M57: OTHERS CONFIG, and then press the F5 (SET) button to display the sub-page

3 Rotate the MULTI CONTROL knob to bring the cursor (*) to M572: TEMP FILE CREATE, and then press the F5 (SET) button.

Preparations 13