Use the VTR maintenance menu to reset registered user names and passwords to the default.
Note
This procedure resets the names and passwords of all registered users.
1 Do steps 1 to 3 in the procedure of “Basic Network Settings” (see page 9) to display the M5: NETWORK page of the maintenance menu.
2 With the HOME button pressed, rotate the MULTI CONTROL knob to bring the cursor (*) to M59: RESET ALL USER and press the F5 (SET) button.
M5 : NETWORK
M50 : IP ADDRESS
M51 : SUBNET MASK
M52 : DEFAULT GATEWAY
M55 : TAPE LEADER CONFIG
M56 : IP CONFIG
M57 : OTHERS CONFIG
M58 :
M59 : RESET ALL USER
The M59: RESET ALL USER page appears.
3 Rotate the MULTI CONTROL knob while holding the HOME button down to change the setting to ON.
M5 : NETWORK
M59 : RESET ALL USER
ON
Push SET Button
– – – – – – Caution – – – – – –
All the user name and
password settings will be changed to factory default.
4 Press the F5 (SET) button.
The message “Complete Turn off/on POWER !!” appears.
M5 : NETWORK
M59 : RESET ALL USER
ON
Complete
Turn off/on POWER !!
5 Restart the
You can reduce the load on the network by setting the maximum transfer rate to the network by the sending side
When required, change the setting using the Setup menu
For details on setup operation, refer to the Operation Manual supplied with the VTR.
MAXIMUM RATE
best effort
best effort (default setting): Send data at the maximumpossible transfer rate.
1 Mbps to 50 Mbps: Limit the data transfer rate to the selected value.
Preparations 15