Chapter1: SettingUp

ConnectingTVAntenna/Cable

Although you can use either an indoor or outdoor antenna with the TV, an outdoor antenna will provide you with better picture
quality. You can receive cable TV by connecting a cable supplied by your local cable company.
75-ohm coaxial cable (round)
Check your antenna cabletype and preparethe end
ofthe cable usingthe F-type connector.
Attach anF-type connector (not supplied).
a7 mm (1/4 inch)10 mm (3/8inch) F-typeconnector
b3mm (1/8 inch)
d
Plug the connector into the VHF/UHF terminal at the
rear of the TV.
(Rear of TV)
VHF/UHF
300-ohm twin-lead cable (flat)
Check your antenna cable type and prepare the end ofthe cable using the 300-ohm twin-lead cable.
Attach the supplied antenna connector.
b Loosen both
screws on the
connector with a
screwdriver.
CAttach the cable
and tighten both
screws with a
screwdriver.
Plug the connector into the VHF/UHF terminal at the
rear of the TV.
(Rearof TV)
VHF/UHF
=_==
=_
#
* Most combination antennas are equipped with asignal
splitter.
Remove the splitter and attach the appropriate connector.
_(for KV-20TS50)
Do not connect the antenna cable to the IR EMITTER terminal.
If you do so, the TV antenna could break.
The IR EMITTER terminal is covered with a plastic cap to
prevent misconnection.
Chapter 1: Setting Up / 1 1