UsingtheCordlessHeadphones(KV-2OTS50only)
Push the tabs on the edges of both
receivers down and up to open the
battery compartment covers.
Insert a size AA (R6) battery intoeach
of the compartments.
Make sure the polarity is correct.
3Close the battery compartment cover.
Battery life
With continuous use, batteries will last:
• up to 120hours (size AA (R6) alkaline battery).
• up to 60 hours (size AA (R6) manganese battery).
If the power indicator darkens and the sound deteriorates, the
batteries might be weak. Replace both of them with new ones.
To avoid damage from possible battery leakage
Remove the batteries ifyou do not plan to use the cordless
headphones for afairlylong time.
J WARNING
Batteries may explode if mistreated. Do not recharge,
disassemble, or dispose of infire.
2
Infrared Emitter
(supplied)
1
IR EMITTER
k
Cordless Headphones
(supplied)
.,,,,t._, :Signal flow
Plug the infrared emitter cable into the IREMITTERterminal.
Do notconnect the antenna cable into the IR EMITTER terminal. If
you do so,the antenna could break. The IR EMITTER terminal is
covered with a plastic cap toprevent misconnection.
Adjust the position and the direction of the infraredemitter.
• Do not cover the infrared emitter.
• Remove obstacles between the emitter and the cordless
headphones.
Turn the headphones power on by using the control on
the headphones.
The power indicator lights up.
Set HEADPHONES to ON. For instructions, see
"Setting HEADPHONES to ON or OFF," p.46.
Adjustthe headphone speakers volume by using the
controls on the headphones. You can adjust the
volume to the right and left speakers separately.
_=
Toprevent hearing damage due to sudden or prolonged excessive volume, do not raise the headphones volume too high, while listening.
Chapter3:Using AdvancedFeatures _ 45