Precautions

Notes on use

•The CDP-D12 must be used within a temperature range of 0°C to 40°C (32°F to 104°F).

•Installing the CDP-D12 in a hot place or in a place exposed to direct sunlight may cause it to malfunction or the color finish to fade. Do not place the CDP-D12 near a heat source such as lighting equipment or a power amplifier.

•After using the CDP-D12 in a place that is moist, dusty place, or exposed to activated gas, clean the surface and the connectors as soon as possible. If you do not, or if the CDP-D12 is kept in such a place, the service life of the player may be shortened.

•Clean the surface and the connectors of the CDP-D12 with a dry, soft cloth. Never use thinner, benzene, alcohol or any other chemicals, since these may mar the finish.

Installation

Do not place the CDP-D12 in the following places:

•On an unstable place or uneven surface

•On a carpet or mattress

•Humid or poorly ventilated places

•Dusty places

•Under direct sunlight or where the temperature is high

•Where the temperature is very low

•Near a tuner, TV set, or video deck (When using the CDP-D12 with the above equipment, the close proximity of the CDP-D12 may cause noise or distortion in audio or visual signals, especially in the case of equipment that use an interior antenna. In this case, it is recommended that an outdoor antenna be used instead.)

Note on adjusting the volume

Compact discs contain less noise than normal records. If you adjust the volume as you listen to the sound between tracks, as you might do with normal records, an unexpectedly high volume may be output, damaging the speakers. Be sure to turn down the volume before the start of playback.

On condensation in the player

If the player is brought directly from a cold place to a warm location, or is placed in a very damp room, moisture may condense inside the player.

Moisture may condense inside the player when the temperature suddenly rises, such as when a heater is turned on. In this event, the player may not operate properly, and damage may even occur to the CD or player mechanism. If there is condensation, remove the CD and leave the player turned on for about an hour until the moisture evaporates. If the player does not operate normally even after a few hours, consult Sony service personnel.

On cleaning

Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzene.

On carrying the player

Always remove the CD before transporting the player.

After inserting the CD

A beep or mechanical noise may be heard. This is caused by the automatic adjustment of the servomechanism inside the player. A noise may also be heard if the inserted CD is warped, due to an automatic adjustment function.

13