Locating a Particular Point in a Track

You can locate a particular point in a track during playback or pause.

There are the three following ways to locate a point within a track:

•Low-speed search

Searches for point at 3 times the normal playback speed.

•Standard-speed search

Searches for point at 20 times the normal playback speed.

•High-speed search

Searches for point at 60 times the normal playback speed. During high-speed search, you must use the time indication to search for a point since sound is not output.

Making menu settings for outputting sound during high-speed search

1 While the player is stopped, press the MENU/ EXIT button.

2 Rotate the AMS control until “PAUSE m/M” appears in the display, and then press the control.

3 Rotate the AMS control until “SOUND ON” appears in the display, and press the control.

4 Press the MENU/EXIT button to complete the setting.

Note

The setting above applies only for high-speed search. The sound is always output for low-speed and standard-speed search regardless of the setting.

Locating a point while

monitoring the sound

This operation is possible only when “PAUSE m/ M” is set to “SOUND ON.”

Press down the mor Mbutton on the player or remote, or press down the SLOW mor Mbutton on the remote during play or pause. You will hear intermittent playback as the disc goes forward or reverses. When you reach the desired point, release the button. The search speed varies depending on the status of the player (playback or pause) and the buttons used.

Buttons used

During play

During pause

 

 

 

m/M on the player

standard

low-speed

 

 

 

m/M on the remote

standard

standard

 

 

 

SLOW m/M

low-speed

low-speed

Locating a point by observing

the time indication

This operation is possible only when “PAUSE m/ M” is set to “SOUND OFF.” No sound is output at this time.

Press down the mor Mbutton on the player or remote, or press down the SLOW mor Mbutton on the remote during playback or pause. When you reach the desired point, release the button. The search speed varies depending on the status of the player (playback or pause) and the buttons used.

Buttons used

During play

During pause

 

 

 

m/M on the player

standard

high-speed

 

 

 

m/M on the remote

standard

high-speed

 

 

 

SLOW m/M

low-speed

low-speed

 

 

 

When “OVER” appears in the display

The disc has reached the end while you’re pressing the

Mbutton. Rotate the AMS control counterclockwise (or press the . button) or press the mbutton to go back.

Note

If the disc reaches the end while you are pressing the

Mbutton or the SLOW M button on the remote during playback, the player stops.

28