For the customers in the U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

The shielded interface cable recommended in this manual must be used with this equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

For the customers in the U.S.A. and Canada

Caution

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

 

 

 

 

 

This label is located on the top

 

 

 

 

 

exterior.

 

 

 

 

 

 

Laser diode properties

 

 

 

Wavelength:

780 nm

 

Emission duration:

Continuous

 

Laser output power:

30 mW (max.)

For the customers in Canada

This Class B digital apparatus complies with Canadian ICES- 003.

For the customers in Europe

This product with the CE marking complies with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community.

Compliance with these directives implies conformity to the following European standards:

EN60065: Product Safety

EN55103-1: Electromagnetic Interference (Emission)

EN55103-2: Electromagnetic Susceptibility (Immunity) This product is intended for use in the following Electromagnetic Environment(s):

E1 (residential), E2 (commercial and light industrial), E3 (urban outdoors), and E4 (controlled EMC environment, ex. TV studio).

Caution

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

The CDP-D12 is classified as a

CLASS 1 LASER PRODUCT. The CLASS 1 LASER PRODUCT label is located on the top exterior.

CAUTION — CLASS 1M INVISIBLE LASER RADIATION WHEN OPEN.

DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS.

Laser diode properties

Class 1M

IEC60825-1:1993+A1:1997+A2:2001

EN60825-1:1994+A11:1996+A2:2001

Wavelength: 780 nm

Emission duration: Continuous

Laser output power: 30 mW (max.)

CDP-D12 er klassifisert som

LASERPRODUKT KLASSE 1. Klassemerkingen for KLASSE 1 er plassert utvendig på oversiden.

ADVARSEL — USYNLIG LASERSTRÅLING KLASSE 1M HVIS ÅPEN. IKKE SE DIREKTE MED OPTISKE INSTRUMENTER.

Spesifikasjoner laserdiode

Klasse 1M

IEC60825-1:1993+A1:1997+A2:2001

EN60825-1:1994+A11:1996+A2:2001

Bølgelengde:

780 nm

Strålingens varighet: Kontinuerlig

Laserens effekt:

30 mW (maks.)

3