Connection
Functions assignable to P.Input1 to P.Input5 (input terminals)
Indication | Function |
|
|
PLAY/PAUSE | The same function as HXbutton on the |
| main unit |
|
|
PLAY | The same function as Hbutton on the |
| remote |
|
|
PAUSE | The same function as Xbutton on the |
| remote |
|
|
STOP | The same function as xbutton |
|
|
AMS + | The same function as >button on the |
| remote |
|
|
AMS – | The same function as .button on the |
| remote |
|
|
FF | The same function as Mbutton |
|
|
REW | The same function as mbutton |
|
|
MARK | The same function as MARK button on the |
| remote |
|
|
LOCATE | The same function as LOCATE button |
|
|
EJECT | The same function as AEJECT button on |
| the main unit |
|
|
Fader PLAY | Performs Fader Play (page 22) |
|
|
1 Track PLAY | The same function as numeric buttons on |
to 20 Track | the remote |
PLAY |
|
|
|
OFF | No operation |
|
|
Functions assignable to P.Output1 to P.Output3 (output | |
| terminals) |
|
|
Indication | Function |
PLAY | Grounding during playback on the player |
|
|
PAUSE | Grounding during pause on the player |
|
|
NO DISC | Grounding during no disc in the disc |
| compartment |
|
|
OFF | Always floating |
|
|
Do the procedure below to change the function of each terminal.
1 Press the MENU/EXIT button while the player is stopped.
“MENU Mode” appears in the display.
2 Rotate the AMS control until “Parallel” appears in the display, and then push the control.
If “Parallel” is already set to “User,” skip this step and step 3, and go to step 4.
3 Rotate the AMS control until “User” appears in the display, and then push the control.
4 Rotate the AMS control until the terminal that you want to assign function to (e.g., “P.Input1” or “P.Output2”) appears in the display, and then push the control.
5 Rotate the AMS control until the function that you want to assign to the terminal that you selected appears in the display, and then push the control. To assign functions to more terminals, repeat steps 4 and 5.
6 Press the MENU/EXIT button to complete the setting.
Notes
•When “Preset” is selected for “Parallel,” you cannot select terminals or assign functions to them. To enable the assigning of functions to terminals, first select “User” for “Parallel.”
•Doing the procedure above with “Preset” selected for “Parallel” allows you to check the factory setting for each terminal.
Electrical specifications for the
PARALLEL connector
Input terminals
Input system Make contact Input ON voltage Less than 0.5 V Input OFF voltage More than 3 V Opening terminal voltage
5 V
Input pulse width More than 100 msec Input standing voltage
Output terminals
Output system | Open collector for NPN transistor |
Remaining voltage at ON | |
| Less than 0.5 V |
Maximum current at ON | |
| 100 mA |
Standing voltage | 20 V |
22