The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound. | •Cancel the ATT function. |
| •Set the fader control to the centre position for |
| system. |
| •Rotate the dial clockwise to adjust the volume. |
The contents of the memory have been erased.
•The power cord or battery has been disconnected.
•The RESET button has been pressed. t Store again into the memory.
Indications do not appear in the Remove the front panel and clean the connectors. See
display. | “Cleaning the connectors” (page 24) for details. |
|
|
No beep sound. | •The beep sound is cancelled (page 22). |
| •If you connect an optional amplifier and do not use the built- |
| in amplifier, the beep sound will be deactivated. |
|
|
CD/Video CD/Super VCD playback
Problem | Cause/Solution |
A disc cannot be loaded. | •Another CD is already loaded. |
| •The CD is forcibly inserted upside down or in the wrong |
| way. |
|
|
Playback does not begin. | Defective or dirty CD. |
|
|
A disc is automatically ejected. | The ambient temperature exceeds 50°C. |
|
|
CD will not be ejected. | You have closed the front panel or pushed the disc forcibly |
| into the unit while the unit was ejecting the disc after you |
| pressed Z. |
| t Press the RESET button. |
|
|
The operation buttons do not | Press the RESET button. |
function. |
|
|
|
The sound skips due to | •The unit is installed at an angle of more than 60°. |
vibration. | •The unit is not installed in a sturdy part of the car. |
|
|
The sound skips. | Defective or dirty CD. |
|
|
| continue to next page t |
27