Sony CRX0811 manual Headphone Jack/Volume Control, Rear Panel, Audio Out Connector, EIDE Connector

Headphone Jack/Volume Control.

To listen to an audio CD from the CD-ROM unit you may insert a standard headphone cable into the headphone jack. If there is a audio CD player utility installed on your PC, you can listen to audio CDs directly from the drive. The software functions like a typical CD player, letting you choose tracks to play, etc. The audio can be heard through your PC’s speakers if you connect the audio out connector of the drive to the CD input of your sound card. The volume control on the front panel controls headphone volume only.

Rear Panel

Audio Out Connector

EIDE Connector

Right Signal Ground

Left Signal

Pin 1

CABLE SELECT

DIGITAL ANALOG

SLAVE

AUDIO

AUDIO

MASTER

HOST INTERFACE

POWER

0 0

R G G L

C S M

39

1

+5

G G +12

S L A

40

2

Frame Ground
Drive Configuration Jumpers	DC Power Connector

EIDE Connector

The drive uses a standard 40-pin IDE connector to be attached to an Enhanced IDE/ATAPI port on the motherboard. See Chapter 3 which describes how to connect your drive to your PC.

Drive Configuration Jumper

The drive configuration jumpers set your drive to be a master or slave drive on the EIDE port. The default position is with the jumper in the Master position.

To set the drive as a slave drive, place the jumper on the Slave position. The third jumper is for Cable Select.

G	ITAL	ANALOG
U					CABLE
	DIO						SELECT
		AUDIO
		R			SLAVE
	0		G G L	C S M		MASTER
							39
				S	L A			HOST
							40	INT

Audio Out Connector

This connector provides two channel, analog line level audio output which may be connected to a sound card.

D
IGITAL	ANALOG			CABLE
AUDIO							SELECT
	AUDIO
0 0				SLAVE
	R G	G L	C	S M	M	ASTER
							39
			S L A					H
							40

DC Power Inlet

The drive attaches to your PC’s standard power cable.

ST INTERFACE

1		POWER
2	+5	G
			G	+12

12 CD-RW Recorder User’s Guide CD-RW Recorder User’s Guide 13