Getting Started

Calibration mic

11 Press C/c to select [YES], then press

.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sounds are output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.

•Before [AUTO CALIBRATION], install the surround amplifier in the appropriate location. If you install the surround amplifier in an improper location, such as another room, proper measurement will not be obtained.

•The environment of the room in which the system is installed may affect measurements. When the measurements differ considerably from the status of the speaker installation, perform the speaker settings manually by following “Settings for the speakers” (page 67).

12 Unplug the calibration mic, press C/c to select [YES], then press .

Quick Setup is finished. All connections and setup operations are complete.

To quit the Quick Setup

Press DISPLAY in any Step.

To recall the Quick Setup display1 Press FUNCTION +/– repeatedly until“DVD” appears in the front panel display.2 Press DISPLAY while the system is in stop mode.

The Control Menu display appears on the TV screen.

3 Press X/x to select [SETUP], then press .

The options for [SETUP] appear.

94( 99)

1(

1)

DVD VIDEO

T

0: 01: 08

 

CUSTOM

CUSTOM

QUICK

4 Press X/x to select [QUICK], then press

.

The Quick Setup display appears.

Setting the type of video output to match your TV

Depending on the connection of the TV

(page 26), select the type of video output of the system.

To select the type of video signal output from the HDMI OUT jack

When you connect the unit and the TV with an HDMI cable, select the type of video signals output from the HDMI OUT jack.

For details, refer also to the operating instructions supplied with the TV/projector, etc.

1 Press FUNCTION +/– repeatedly until

“DVD” appears in the front panel display.

2 Press DISPLAY while the system is in stop mode.

The Control Menu display appears on the TV screen.

38GB