Sony DAVHDX279W, HDX277WC manual Settingup the WirelessSystem, 42us, DA V-HDX279W/DA V-HDX576WFonly

Step4: Settingup the WirelessSystem

(DA V-HDX279W/DA V-HDX576WF only)

To use tire wireless system, you need to set up tile SmToundamplifier. Before setting, make sure that tile wireless transceivers are inserted

into the unit and the surround amplifier correctly (page 38).

This wireless system is called "S-AIR."For details of the S-AIR fimction, see "Using all S-AIR Product" (page 83).

I/O

POWER / ON LINE

Indicator

POWER S-AIR ID switch

To check the transmission status

You can check tile status of sound transmission between the unit and snrround amplifier by checking the POWER / ON LINE indicator of the surround amplifier.

POWER / ON LINE Status indicator

Turns	green.	Sound		transmission			is
		established.
Flashes	green.	Sound		transmission			is	not
		established.
		For	details,			see "Surround
		amplifier			operation"
		(page		105).
Turns	red.	The	surround			amplifier		does
		not	otltput		sound.
		For	details,			see "Surround
		amplifier			operation"
		(page		105).
Turns	off.	The	surround			amplifier		turns
		off or its protection is active.
		For	details,			see "Surround
		amplifier			operation"
		(page		1(t5).

PHONESjackSURROUND

SELECTOR switch

The unit transmits sound to the surround amplifier that is connected to the surround speakers. To establish sound transmission. perlimn the lollowiug Steps.

1 Press I/_ on the unit.

The system turns on.

2 Make sure that the SURROUND SELECTOR switch of the surround amplifier is set to SURROUND.

3Set the S-AIR ID switch of the surround amplifier to A.

4Press POWER on the surround amplifier.

The POWER / ON LINE indicator turns

green. If not, check tile transmission status as follows.

To enjoy the sound by using

headphones

You can enjoy the system's sotmd ill a place apart from the nnit by connecting tile headphones to the PHONES jack on the surround amplifier.

•When you connect headphones to the surround amplifier, neither the unit nor the surround amplifier outputs sound from the system's speakers.

•The volume of the unit may become minimum if you turn off the surround amplifier while the headphones arc connected to the surround amplifier, or radio reception is poor. In this case, "HPNO LINK" and "VOLUME MIN" appear alternately ill the front panel display. Check radio reception, and set the volume again.

When you use the multiple S-AIR product

You call prevent miss transmission between the S-AIR products by setting a different ID for each

S-AIR product. For details, see "Establishing sound transmission between tile unit and S-AIR

sub unit (ID setting)" (page 83).

42us