Sony HDX277WC, DAVHDX279W, HDX576WF 70us, •Black Level, • Black Level Component Out, Hdmi Setup

The system outputs the progressive signal for 5 seconds. Check that the screen is

displayed correctly.

3 Press ÷/+ to select [YES].

The system outputs the progressive signal. If you select [NO], the system will not output the progressive signal.

•[PROGRESSIVE (COMPONENT OUT)] is effective only when you connect the unit and TV with a component video cord (page 28).

•[4:3 OUTPUT]

When you use a 16:9 aspect ratio TV, you can adjust the aspect ratio to watch 4:3 aspect ratio signals. If you can change the aspect ratio on your TV, change the setting on your TV. not the system.

[FULL]: Select this when you can change the aspect ratio on your TV.

[NORMAL]: Select this when you cannot change the aspect ratio on your TV. A 16:9 aspect ratio signal with black bands on left and right sides of the image appears.

16:9 aspect ratio TV

m

•14:3OUTPUT] is effective only when you set ITV TYPE] in [VIDEO SETUP] to [I 6:91.

•[BLACK LEVEL]

You cml select the black level (setup level) tbr the video signals output from the jacks other than COMPONENT VIDEO OUT/HDMI OUT.

[ON]: The standard level.

[OFF]: You can lower the standard black level. Use this when the picture becomes too white.

• [BLACK LEVEL (COMPONENT OUT)]

You can select the black level (setup level) tbr the video signals output from the

COMPONENT VIDEO OUT jacks.

You cannot select this and the setting is not el'ti:ctive when the system outputs progressive signal.

_: You can sel Ihe black level of the output signal to the standard level.

ION]: You can raise the standard hlack level. Use this when the picture becomes too black.

•[PAUSE MODE] (DVD VIDEO/DVD-R/

DVD-RW only)

You can select the picture in pause mode.

[AUTO]: The picture, including subjects that move dynamically, is output with no .jitter. Normally select this position.

[FRAME]: The picture, including sulzjects that do not move dynamically, is output in high resolution.

[HDMI SETUP]

HDMISETUP

•[HDMI RESOLUTION]

You can select the type of vide() signal that is output tTom the HDMI OUT jack. For details, see "To select the type of vide() signal output fl'om the HDMI OUT jack" (page 46).

[AUTO (1920 x 1080p)]: The system outputs the optimal video signal t_)r the connected TV. [1920 x 1080i]: Tbe system outputs 1920 x 1(180i ': video signals.

[I 280 x 720p]: The system outputs 1280 x 721)p* video signals.

[720 x 480p]**: The system outpnts 720 x

480p '_ video signals.

"i: interlace, p: pregrcssive

70us