Audio dubbing

Adding audio on a recorded tape

Choose a connection described on the previous pages, and connect audio equipment or microphone to your camcorder. Then follow the procedure below.

(1) Insert the recorded tape into your camcorder.

(2) Set the POWER switch to VCR on your camcorder.

(3) Locate the recording start point by pressing N. Then press Xat the point where you want to start recording to set your camcorder to the playback pause.

(4) Press AUDIO DUB on the Remote Commander. The green Xindicator appears on screen.

(5) Press Xand start playing back the audio you want to record at the same time. The new sound is recorded in stereo 2 (ST2) during playback. While audio is being recorded, the red appears on the screen.

(6) Press xat the point where you want to stop recording.

AUDIO DUB

To add audio more precisely

Press ZERO SET MEMORY on the Remote Commander at the point where you want to stop recording later in the playback.

Carry out from steps 3 to 5. Recording automatically stops at the point where ZERO SET MEMORY was pressed.

108