Sony DCR-TRV40, DCR-TRV50 (1) Set the IR SETUP code, Dubbing only desired scenes – Digital program editing (on tapes), Step 2: Setting the VCR to operate with the A/V connecting cable

Dubbing only desired scenes – Digital program editing (on tapes)Step 2: Setting the VCR to operate with the A/V connecting cable

To edit using the VCR, send the control signal by infrared rays to the remote sensor on the VCR.

When you connect using an A/V connecting cable, follow the procedure below, steps (1) to (4), to send the control signal correctly.

(1) Set the IR SETUP code

1Set the POWER switch to VCR on your camcorder.

2Turn the power of the connected VCR on, then set the input selector to LINE. When you connect a video camera recorder, set its power switch to VCR/VTR.

3Press MENU, then turn the SEL/PUSH EXEC dial to select VIDEO EDIT in

, then press the dial (p. 209).

4Turn the SEL/PUSH EXEC dial to select TAPE, then press the dial.

5 Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.

6 Turn the SEL/PUSH EXEC dial to select CONTROL, then press the dial.

7 Turn the SEL/PUSH EXEC dial to select IR, then press the dial.

8 Turn the SEL/PUSH EXEC dial to select IR SETUP and turn the dial to select IR SETUP code number of your VCR, then press the dial.

Check the code in “About IR SETUP codes.” (p. 91)

MENU

3							6
	OTHERS			OTHERS				VIDEO EDIT		0:08:55:06
		DATA CODE			DATA CODE			EDIT SET
		BEEP			BEEP				CONTROL		IR
		COMMANDER			COMMANDER				ADJ TEST		i. LINK
		DISPLAY			DISPLAY				”CUT–IN”
		VIDEO EDIT	READY		VIDEO EDIT	RETURN			”CUT–OUT”
		RETURN			RETURN	TAPE			IR SETUP
						MEMORY			PAUSEMODE
									IR TEST
									RETURN
	[MENU] : END			[MENU] : END				[MENU] : END

4								8
	OTHERS			VIDEO EDIT			0:08:55:06		VIDEO EDIT		0:08:55:06
		DATA CODE		MARK		1	IN		EDIT SET
		BEEP		UNDO						CONTROL
		COMMANDER		ERASE ALL						ADJ TEST
		DISPLAY	RETURN	START						”CUT–IN”
		VIDEO EDIT		EDIT SET						”CUT–OUT”
		RETURN	TAPE								3
			MEMORY	TOTAL	0:00:00:00					PAUSEMODE
				SCENE 0						IR TEST
	[MENU] : END			[MENU] : END						RETURN
									[MENU] : END

5

VIDEO EDIT		0:08:55:06
MARK
UNDO
ERASE ALL
START		IR
EDIT SET
TOTAL	0:00:00:00
SCENE	0

[MENU] : END

VIDEO EDIT		0:08:55:06
EDIT SET		IR
	CONTROL
	ADJ TEST
	”CUT–IN”
	”CUT–OUT”
	IR SETUP
	PAUSEMODE
	IR TEST
	RETURN
[MENU] : END

90